Fig. D: Interior views
Notice! RH/Temperature
The sensor cable is attached onto the interior of panel. Before
Setting aside the panel, unclip and slide it out from the cable tie
Advanced Pump Cleaning
Complete as needed
1. Press the drain button to drain the water from the reservoir (a wet-dry
vacuum or towels can be used to remove any remaining water).
2. Unplug the dehumidifier and remove the cover so you have access
to the pump.
3. Remove the pump head from the reservoir by unscrewing the screw.
Wipe reservoir clean with a paper towel.
4. Reassemble pump.
5. Mix a 16 ounce solution of bleach (1 oz 15 oz water) OR
vinegar (4 oz white v 12 oz water).
6. Pour the cleaning solution into the drain tray at the base of the coils.
If any cleaning solution gets on the coils, flush with water.
7. Allow solution to soak for 15 minutes.
8. Reconnect the dehumidifier to power.
9. Fill the reservoir with water (16-32 ounces) and flush/cycle the pump
at least 2x.
Unit Diagram
Handle
Side Panel
Filter Cover
Control Panel
Pre-Filter
Discharge Grille
Power Cord
Auxiliary Terminals
Drain Hose
Connection
11
12
Before setting aside the panel, detach the sensor cable. When
Replacing the panel, remember to reinstall the cable.
Air in/ react out panel. Only remove this panel
for routine cleaning and inspection
Storage compart-ment.
Blower
Belt tensioner
(see detailbe-
low)
Desiccant
rotor
Reactair
outlet
Belt tensioner.Lift arm upward
to release belt.
Inspect the blower and clean as necessary
Ensure that the impeller rotates without restrictions. Wipe clean or vacuum all surfaces.
Inspect the desiccant rotor and clean as necessary
Use pressurized air or dry-vacuum to get rid of dust collected on the rotor.
Inspect the rotor belt.
Check for cracks and excessive wear. For replacement
options, contact your local distributor or retailer.
Vacuum the interior
to get rid of debris and dust. Wipe the interior surface using a
clean and dry cloth. Do not attempt to use water or any kind of cleaning solution.
Take caution not to damage the electronic sensors and lead wires.
Reattach the side panel:
Reattach the sensor cable inside the panel. Thread the cable
upwards over the zip tie and plug it in. Install the screws and fasten sing fingers only,
starting from the top working downwards. Once the screws are correctly started, use a
hand screw to tighten them lightly, do not overtighten the screws. Also, do not tighten the
screws using a power screw since they tend to impact more pressure.
PUMP PURGE BUTTON
When the Pump Purge Button is used, the control panel displays
the following messages.
C O N T R O L P A N E L
M E S S A G E
E X P L A N A T I O N
PLEASE WAIT
CALCULATING
PERFORMANCE
XXX PINTS/24H
The dehumidifier is calculating water removal..
The unit displays the calculated water removal
in Pints per day.
SYSTEM MESSAGES
The Control Panel will display the following messages based on system performance
and environmental conditions. User action, if any is required, is indicated in
the third column.
C O N T R O L P A N E L
M E S S A G E
E X P L A N A T I O N
U S E R A C T I O N
INITIALIZING
Unit is powering up.
FIRMWARE
VERSION XXX
Indicates the control board
firmware version number
None
None
