Maintenance
The filter should be regularly checked. It comes with a high efficiency MERV-10 filter. Note that
you should avoid operating the unit with a dirty filter. If you do so, the performance of the
dehumidifier will be compromised. The compressor may also keep turning on and off. The unit’s
filter allows you to vacuum clean it several times before you will ever need to replace it. If you
need to replace your filter, you can easily get it from Abestorm. You can also access it locally.
WARNING:
You should not ever operate the unit without the filter. If you do so, the unit may have to
under go a major repair. It will have to be disassembled and the coils replaced or cleaned.
Excess dirt causes clogging in the system.
Instructions for use of filter
9
8
E1: Humidity Sensor or Communication Error
Solution: Check to ensure that the sensor wire is connected at
both ends, if no issues are visible, the sensor may be faulty.
E4: Problem with Pump
Solution: Verify that the pump is properly installed and
functioning. If so, unplug the unit for two minutes, then restart.
Solution: Increase the room temperature so it is within operation
range (above 35.6
℉
). If error is still displayed, check the sensor.
HI: Room Temperature is above 105
Solution: Decrease the room temperature so it is within operating
range (below 105
℉
). If error is still displayed, check the sensor.
LO: Room Temperature is below 35.6
If the maine has an error and needs service,
the onboard control system will display a
diagnostic code. If E1, E4, HI or LO is
displayed on the vehicle control screen,
please refer to the following:
Содержание SLGR Elite
Страница 5: ...7 6 ...
