Abestorm OZ-G2000, Руководство пользователя

Страница: 8 / 13

6
Transportation and Storage
If you store or transport the device incorrectly, the device may be damaged.
Pay attention to information about transportation and storage.
Transportation
Before
transporting the equipment, please observe the following regulations:
If the device was in use before, please wait until the timing period is over before transferring the
device.
Turn off the device.
Hold the power plug while unplugging the power cord from the power outlet.
Do not drag the device with the power cord during transportation to prevent the device from moving
and vibrating to avoid damage to the electrode.
After transporting the equipment, please observe the following regulations:
Install the equipment in an upright position after transportation.
Storage
When the device is not in use, please observe the following storage conditions:
Store the Abestorm OZ-G2000 in a dry place to avoid the influence of bad weather, and cover it to
protect it from invasive dust.
When the equipment is not in use, always disconnect the power supply.
Clean Electrode
Ensure that the equipment is protected from splash water.
Make sure that there are no obstructions at the air inlet and outlet.
Make sure to place the device on a dry and vibration-free surface.
If possible, place the device in the center of the room to ensure optimal air circulation.
Do not use the device before the electrodes are completely dry.
Do not install this machine near flammable substances or gases.
Only use the Abestorm OZ-G2000 according to the parameters provided in the "Technical Data" chapter.
The following requirements must be met when installing the Abestorm OZ-G2000:
Use a dry (lint-free) or damp cloth to clean the components. After cleaning, make sure that no fibers
(fluff) remain on the electrode.
The electrode can be cleaned in the built-in state. Before cleaning the electrode, check for cracks. Do
not use damaged parts!