abc PU00, Руководство пользователя

Страница: 37 / 95

35
EN
Functions 0.37-7.5kW 11-22kW Specification
RS485
communic
ation
RS+, RS- RS+, RS-
Max Baud Rate: 38400bit/s;
Configurable termination resistor, open in default
Digital
Input
FWD, REV
FWD,
REV
，
DI1
1. Input type: NPN Or low voltage input; 2. Input
impedance
：
3.6kΩ
；
3. Input Voltage
：
0-30V
；
Digital
output
DO1 -
1. Output mode: Open Collector
2. Output current: max 40Ma;
Analogue
input
- AI1
Configurable as analogue voltage inputs, analogue current
inputs as well as digital inputs.
1
．
As Analogue Voltage Inputs:
Input Impedance: 10kΩ;
Input Voltage Range: 0~10V;
2
．
As Analogue Current Inputs:
Input Impedance: ≤500Ω;
Input Current Range: 0~20mA;
10V
power
supply
- +10V Max 10mA
Relay
output
- KA-KB
Resistive Load: 250VAC 3A/30VDC 3A
；
Inductive Load: 250VAC 0.2A/24VDC 0.1A
(cosφ=0.4)
；
GND GND GND Grounding for both digital and analogue signals
LED
Name
Color Reponses Meaning
POWER Green
Always On Powered and power supply ok
Always Off Not power, or problem in power supply
STATUS RED
Always Off Product is OK
Flashing Warning with Fault
Always On Alarm with Fault
5.
Basic Application Guide
5.1. Control with Keypad

Ensure the product is working in Local Mode (L/R light flashing), or by setting parameter
P6.31=1 to switch to Local Mode.

Press the“▲” and “▼”key to adjust the output frequency. By default, each time you press it, the
frequency increases or decelerates 0.1Hz.

Press the “RUN” key to start the inverter, and adjust the setting frequency by pressing the
“▲” and “▼” key.

Press the “STOP” key to stop the inverter.
5.2. Control with Terminals
First ensure the product is working in Remote Mode (L/R light always ON). If not, switch the product
to the Remote Mode by setting parameter P6.31=0. The product is default in Remote Mode.