Communication
42/14-42-EN Sensyflow
FMT700-P
29
Pos: 15.16 /Kommunikation/Durchfluss/FMT700-P/Länge der übertragenen Strings @ 33\mod_1253169529781_3101.doc @ 301859 @ 4
6.1.1.7 Length of transmitted strings
Enter the command
X$
to access the string table. When a monitor is connected, the following
text appears:
CLS
Length of transmitted strings:
String
Length in
hexadecimal format
Length in
decimal format
<XTT> 03AD
941
<XB> 0421
1057
<XF> 02C6
710
<XS> 0020
32
<XH>
Resets
interface
<XE> 0020
32
<XA> 0020
32
<XZ> 0025
37
<XSR> 002A
42
<XTR> 0012
18
<XU0> 0022
34
<XU1> 002F
47
<XSW1> 001B
27
<XSW2> 001B
27
<X$> 03AD
941
<XT1> 0034
52
<XT2> 0034
52
Comment
1.
<XS> transmits constantly
2.
Each command must end with CR
Important (Notice)
• 4 characters must always be entered when setting the measuring rate (see section 5.3.1),
e.g., for a SAMPLE RATE of 50, the command XZ _ _ 50
CR
must be entered.
• During constant transmission mode, no other operating mode can be set via the serial
interface. The RS 232 C serial interface is blocked and can only be enabled using XH
CR
.
• When the meter is being operated, there is no conflict between the serial interface and the
keypad on the front panel. No priority circuit is required.
• During FAST MODE, all the values and tables stored in the memory (texts, temperatures,
lists, etc.) can be accessed via the serial interface.
• While this is happening (processing time), FAST MODE is interrupted (analog value is
retained). Once processing is complete, FAST MODE is resumed.
• You can exit this operating mode again using the commands
CR
or XZ
CR
.
Pos: 15.17 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830 @
