•
Abbreviations and acronyms in this manual are spelled out in the glossary. The
glossary also contains definitions of important terms.
•
Push button navigation in the LHMI menu structure is presented by using the push
button icons.
For example, to navigate between the options, use
and
.
•
HMI menu paths are presented in bold.
For example, select
Main menu/Settings
.
•
LHMI messages are shown in Courier font.
For example, to save the changes in non-volatile memory, select
Yes
and press
.
•
Parameter names are shown in italics.
For example, the function can be enabled and disabled with the
Operation
setting.
•
Each function block symbol shows the available input/output signal.
•
the character ^ in front of an input/output signal name indicates that the signal
name may be customized using the PCM600 software.
•
the character * after an input/output signal name indicates that the signal must
be connected to another function block in the application configuration to
achieve a valid application configuration.
•
Dimensions are provided both in inches and mm. If it is not specifically mentioned
then the dimension is in mm.
1.4.3
Functions included in 650 series IEDs
Table 1:
Main protection functions
IEC 61850 or Function
name
ANSI
Function description
Differential protection
T2WPDIF
87T
Transformer differential protection, two winding
T3WPDIF
87T
Transformer differential protection, three winding
GENPDIF
87G
Generator differential protection
REFPDIF
87N
Restricted ground fault protection, low impedance
HZPDIF
87
1Ph High impedance differential protection
Impedance protection
ZQMPDIS
21
Five-zone distance protection, Quadrilateral and Mho characteristic
FDPSPDIS
21
Phase selection with load enchroachment, quadrilateral characteristic
FMPSPDIS
21
Faulty phase identification with load enchroachment for mho
ZDNRDIR
21D
Directional impedance quadrilateral and mho
PPLPHIZ
Phase preference logic
ZMRPSB
68
Power swing detection
ZCVPSOF
Automatic switch onto fault logic, voltage-and current-based
Table continues on next page
Section 1
1MRK 511 281-UUS A
Introduction
14
650 series ANSI
Communication protocol manual
Содержание Relion 650 series ANSI
