ABB Relion 630 Series, Техническое руководство

Страница: 363 / 380

10.2.3 Binary inputs
The binary inputs can be used, for example, for status indications, to generate a
blocking signal, to unlatch output contacts, to trigger the disturbance recorder or for
remote control of IED settings.
Each signal connector terminal is dimensioned for one 0.5...2.5 mm
2
wire or for two
0.5...1.0 mm
2
wires.
Use only DC power for the binary inputs. Use of AC power, including
full- or half-wave rectified AC power, may cause damage to the binary
input modules.
Table 359: Binary inputs X304,4U half 19”
Terminal Description ACT info
Hardware module
instance
Hardware channel
X304-1 Common - for inputs 1-4
X304-2 Binary input 1 + COM_101 BI1
X304-3 Binary input 2 + COM_101 BI2
X304-4 Binary input 3 + COM_101 BI3
X304-5 Binary input 4 + COM_101 BI4
X304-6 Common - for inputs 5-8
X304-7 Binary input 5 + COM_101 BI5
X304-8 Binary input 6 + COM_101 BI6
X304-9 Binary input 7 + COM_101 BI7
X304-10 Binary input 8 + COM_101 BI8
X304-11 Common - for inputs 9-11
X304-12 Binary input 9 + COM_101 BI9
X304-13 Binary input 10 + COM_101 BI10
X304-14 Binary input 11 + COM_101 BI11
X304-15 Common - for inputs 12-14
X304-16 Binary input 12 + COM_101 BI12
X304-17 Binary input 13 + COM_101 BI13
X304-18 Binary input 14 + COM_101 BI14
1MRS757256 F
Section 10
Device's physical connections
PML630/Compact Load-Shedding Solution 357
Technical Manual