A071010 V2 EN
Figure 80:
Changing the LHMI language
To change the language using a shortcut, press
and
simultaneously anywhere in the menu.
8.5.2.2
Adjusting the display contrast
Adjust the display contrast anywhere in the menu structure to obtain optimal
readability.
•
To increase the contrast, press simultaneously
and
.
•
To decrease the contrast, press simultaneously
and
.
The selected contrast value is stored in the non-volatile memory if you are logged
in and authorized to control the IED. After an auxiliary power failure, the contrast
is restored.
8.5.2.3
Changing display symbols
Use the keypad to switch between the display symbols IEC 61850, IEC 60617 and
IEC-ANSI.
1.
Select
Main Menu/Configuration/HMI/FB naming convention
and press
.
2.
Change the display symbols with
or
.
3.
Press
to confirm the selection.
The IED has to be rebooted if the WHMI display symbols are
changed. With the LHMI, the change takes effect immediately.
Section 8
1MRS756708 C
Commissioning
110
615 series
Operation Manual