ABB Power2 Series, Инструкция по сборке

Страница: 3 / 32

Assembly Instructions / Power2 500-M
Table of contents
© Copyright 2020 ABB. All rights reserved. HZTL455311P0009_EN Rev.A July 2020
Assembly Instructions
1 Introduction............................................................................................................ 2
1.1 Purpose of the assembly instructions....................................................................... 2
1.2 Definition of target group ........................................................................................... 2
1.3 Symbols, definitions...................................................................................................... 2
1.4 Definition of warning, caution, note ......................................................................... 4
1.5 Definition of mandatory signs ................................................................................... 4
2 Safety ...................................................................................................................... 5
2.1 Introduction .................................................................................................................... 5
2.2 Lifting of loads .............................................................................................................. 6
2.3 Occupational safety ...................................................................................................... 7
3 Weight and transportation of the low-pressure and the high-pressure
stages...................................................................
...........
...................................... 10
4 Installing the low-pressure stage ....................................................................... 11
4.1 Placing the low-pressure stage on the bracket and aligning ............................. 12
4.2 Steps for fastening the low-pressure stage .......................................................... 13
5 Installing the high-pressure stage..................................................................... 19
5.1 Inserting gaskets ......................................................................................................... 19
5.2 Placing the high-pressure stage on the bracket .................................................. 20
5.3 Steps for fastening the high-pressure stage......................................................... 22
5.4 Tightening the clamping nut .................................................................................... 24
5.5 Completion work, if required ................................................................................... 25
6 Storage of new low-pressure and high-pressure stages................................ 26
7 Further information............................................................................................. 28