Page 3
© 2021 ABB. All rights reserved.
Quick Start Guide
Information: Breaker Location Diagram
Battery
Loads
AC
One Shelf System
Battery
Priority
Non
-
Priority
AC
Loads
Two Shelf System
Step 5
-
Connect Batteries
-
skip if no batteries installed
Install Battery Breaker Kits
-
skip if battery breakers are installed or batteries are not present
1. Connect alarm wire to battery breaker (wires provided).
Connect Fastons to breaker terminals.
Terminal 11
-
Red
Terminal 12
-
Black
2. Mount breaker to DIN rail.
a. Verify that breaker is OFF (handle down).
b. Fully open the screw connections at breaker
bottom
-
#2 Phillips
c. Slide breaker over bus tabs and engage top DIN rail fully
IMPORTANT
-
Verify top DIN rail engagement.
d. Tighten the breaker bottom connection
-
#2 Phillips
3. Connect alarm wires to Alarm Card HDR3.
BAT1 Aux + Red
BAT1 Aux
-
Black
a. Run wires to HDR3.
b. Cut wires.
c. Strip 12 mm
(1/2”).
d. Push release lever, insert wire, release lever, Pull
wire to verify.
4. Repeat for additional Battery Breakers, BAT2, etc