INSTALLATION GUIDE
REV. D
4/5
Installation and mounting
Read and understand ‘Magne Product manual’ and ‘Eden Product manual’ before starting the
installation.
Note!
In the following step by step instructions, a Magne 4 is mounted on a right opened sliding
door.
1.
Mount the Magne fitting on to the fence.
Note!
Orientation depends on in which
direction the door is opened.
Note!
Mount the bracket near to the handle
used for opening the door.
2.
Mount Magne on to the bracket using 2 pcs
M6x20 screws.
Note!
If Magne M12-contact (cable) should be
pointing up, use lower and center M6-installation
holes.
3.
Pre-assemble anchor plate fitting with cellular
rubber, tape, anchor plate and Eva.
- Mount anchor plate on to the fitting using a
M8x20 screw with thread locking paste and
tighten it smoothly.
- Insert 2 pcs DA2 distances on the backside of
Eva and mount it on to the fitting using 2 pcs
M4x14 screws.
Note!
Make sure Eva is oriented and
positioned to fit the Magne model that is used.
Note!
Do not overtighten the screws. Do not
leave out DA2 distances. This can deform the
anchor plate or Eva, causing reduced or no
holding force.
Note!
Attach one tape between the fitting
and cellular rubber and one tape between the
anchor plate and cellular rubber. The tape
prevents the cellular rubber and anchor plate
from rotating
.
Anchor plate
and tape
M8x20
max. 3 Nm
M4x14
max. 0.5 Nm
DA2
Cellular rubber
and tape
