ABB IM300-I, Руководство по эксплуатации

Страница: 36 / 109

IM300 Intelligent Power Monitoring Instrument
34
Fig 3-3-3 Parameter error
Fig. 3-3-4 Communication
parameter settings page
password, or to stay on this page.
When entering the parameter setting screen, as this page
parameter setting is completed, press the top button will be
prompted to save the current screen to set the parameters as shown
in fig. 3-3-2. "Y" on behalf of YES, that is, the set parameters are
stored, "N" on behalf of NO, that is not stored parameters. Press
button to make
"Y" or "N" option, press button.
Select the parameters are valid after the "Y" and press the button to confirm ,
such as setting, then store the current parameters; if not legitimate, upper display
shows "ERR" word prompts, as shown, the parameter is not stored 3-3-3. At this point
press
button to re-set parameters, scroll buttons can also be .
Note: No matter which screen parameter setting page, press the button and
button to exit the parameter setting mode,returns single button display mode. In
the parameter setting page, if you do not press button to activate the current
settings page, this page or activation button and did not press or button
parameter modification, then press button will scroll directly, this page is not
stored in the parameter. The screen will go back to the single button mode
automatically if there is no operation on buttons in ten minute. .
Press the top left button until the screen shows word 'UP', then press
button to scroll upward; press button until the top left of the screen display after
the words 'DWN', press the button down scroll.
S
creen 1: Communication parameters settings
This page is used to set the IM300
communication address, baud rate and
transmission format. Top of the screen displays
the word "COMM", indicating the current page
for the communications parameter setting page.
As shown in fig. 3-3-4, communication
address range is 1 to 254; baud total of 1.2k,
2.4k, 4.8k, 9.6k, 19.2kbps five kinds to choose from;
there are four kind of transmission formats: 0,1,2,3. (The details refer to 3.2.3 display