11
A K D - 20 A N D E NTE LLYS I S
LO W VO LTAG E S W I TC H G E A R
Lifting plates must
be removed where
sections are joined
—
Front view
—
Side view
—
Side view
Roller
—
Fig. 2.8
Method of rolling
equipment into place
—
Fig. 2.9
Recommended
method of jacking
outdoor equipment
Wood beam
Note: If shipping skids are removed prior to final
placement of equipment, rollers may only be used
to move the equipment in a direction parallel to
the front.
Remarque: Si vous retirez les cales d'expédition
avant le placement final de l'équipement, vous
pouvez utiliser des rouleaux pour le déplacer,
uniquement dans le sens parallèle à l'avant.
6. Carefully lower the gear until it rests on the
rollers (Fig. 2.7).
7. While carefully pushing the switchgear to its final
site position, the rollers that are freed from the
rear of the switchgear are then repositioned at
the forward end. This procedure should be
continued until the switchgear is in its final
location (Fig. 2.8).
8. When the switchgear is in its final position,
remove all lug bolts holding the shipping skids
to the switchgear line-up.
9. Insert the tines of the forklift at one end of
the line-up, raise slightly, and remove the
loose rollers.
10. Lower the end of the gear carefully
to the floor.
11. Raise the other end of the line-up slightly and
remove the remaining roller at that end.
