ABB Fronius TPS 320i, Руководство по применению, Страница: 68 / 88

Settings
In the Settings section you can change the units from Metric to Imperial , and the
standard from EN Standard (European) to the AWS (American Welding Society).
This only applies to the values shown in the add-in (Wiresize, Material).
It also shows the current interface mode ( Job Mode or Program Mode ).
xx1900002433
Note
If the welder is not connected to the welder but in the same network as the robot
controller, then
WelderConnecteToRC is active.
If the welder service port for some reason is not connected to the robot controller,
the checkbox
WelderConnecteToRC must be unchecked. In that case, the user
has to specify the local path where the weld modes and JobList should be
downloaded. The default path is the following:
C:\Users\XXXXXXXX\Documents\RobotStudio\FroniusTPSiUtility\SynergicLines
It is not recommended to change this path, however, it is possible to do so.
If the files are downloaded, you must connect to a real controller and copy the with
the
Copy Files button. This button will appear if the checkbox
WelderConnecteToRC is unchecked.
Your files will then be copied to the following location:
C:\Users\XXXXXXXX\Documents\RobotStudio\FroniusTPSiUtility\Systemname\
SynergicLines\T_ROB1
If the files are copied, you can start selecting the weld modes and download them
to the controller.
68 Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
3HAC065012-001 Revision: C
© Copyright 2004-2021 ABB. All rights reserved.
5 The Fronius TPS/i RobotStudio Add-In
5.2 Overview of the Fronius TPS/i Add-In
Continued