FAM3200
| CI/FAM3200-EN Rev. B 9
4.1.2
Factory plate
In addition to the name plate, the factory plate is also on the
meter tube of the flowmeter.
Fig. 4:
Factory plate
1
CE mark
2
Serial number of the sensor
3
Reason for exception under article 4, paragraph 3 of the Pressure
Equipment Directive
4
Measuring medium temperature
5
Manufacturer's address
6
Year of construction
7
Material of the pressure-bearing part (wetted part)
8
Nominal diameter / nominal pressure rating
The reason for exception according to article 4 paragraph 3 of
the Pressure Equipment Directive is specified under PED.
The pressure equipment is classified in the SEP (= Sound
Engineering Practice) "Good Engineering Practice" category.
NOTE
The measuring medium temperature specified on the factory
plate only applies for the meter tube.
Depending on the device design (options, Ex approval), the
permissible measuring medium temperature may deviate
from the specified range.
The information on the permissible measuring medium
temperature (T
med
) can be found in chapter "Specifications"
on page 16.
5
Transport and storage
5.1
Inspection
Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.
5.2
Transport
— The center of gravity of some devices is not at the center
of the equipment.
— Use the any available attachment points on the device for
transport.
— Ensure that all transport locking devices are available and
correctly installed.
— Transport packaging marked visibly with the note "Caution
Glass".
5.3
Storage
Bear the following points in mind when storing devices:
— Store the device in its original packaging in a dry and
dust-free location.
— Observe the permitted ambient conditions for transport
and storage.
— Avoid storing the device in direct sunlight.
— In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.
The ambient conditions for the transport and storage of the
device correspond to the ambient conditions for operation of
the device.
Adhere to the device data sheet!
5.4
Returning devices
For the return of devices, follow the instructions in the chapter
"Returning devices" on page 15.
G11967
Ser.-No.: D10A32_5 / 123456
1/2"NPT / 100 bar
Material: 1.4571
Manufactured: 2015 PED: SEP
Tmed = -30°C...+100°C
ABB Automation Products GmbH
37079 Göttingen - Made in Germany -
1
2
3
4
5
6
7
8
