![background image](http://html.mh-extra.com/html/abb/cp430/cp430_installation-and-operation-manual_2351021.webp)
Operation
20
ABB, 1SBC159103M0201
7.4 Bench and Function Tests
Set dip switches
SW3
and
SW4 = OFF
to be able to run the bench and function
tests for the CP430. Turn on the operator terminal to display the following
screen:
The bench test performs an overall hardware test, and the function test lets the
user select which item to be tested.
7.5 Setting Parameters
There are two ways to configure working parameters; to set parameters in the
operator terminal or in CP400Soft.
To set parameters in the operator terminal, select
F2 - Confg
in the system
menu.
To set parameters in CP400Soft, select
Application/Workstation Setup
. Select
the
Connection
tab to set communication parameters.
Note:
The bench test will clear the application data of the operator terminal.
Note:
Remember to set dip switch
SW5 = ON
if parameters are set in the operator
terminal.
Note:
Remember to set dip switch
SW5 = OFF
if parameters are set in CP400Soft.
MA00824B_MAEN859.book Page 20 Tuesday, June 5, 2007 10:34 AM