2
TEMPERATURE MONITORING DEVICE COMEM DTI AND COMEM EDTI
- INSTRUCTION MANUAL
6.
Programming of the device
11
6.1 Selection of the HOLD function
11
6.2 Selection of the number of active inputs
12
6.3 Control ventilation
12
6.4 Selection of the threshold of switch on and switch off
ventilation 13
6.5 Selection of the alarm and trip threshold
13
6.6 Selection of address network identification for the
communication of the serial port (MODBUS-RTU protocol)
14
6.7 Selection of the baud rate
14
6.8 Selection data bit and stop bit
15
6.9 Selection of the linked channel with the analogue output
16
6.10 Configuration output signal
17
6.11 Configuration diagnostic probes
18
6.12 Exit from the programming phase
18
7.
Modality of tripping and restore 19
7.1 Alarm
19
7.2 Trip
19
7.3 To silence alarm
19
8. Diagnostic 20
9.
Visualization of the maximum measured temperature 21
10. Visualization of the channels with the higher temperature 22
11. Test of the light signaling 22
12. Exclusion of the input probes not used 22
13. Technical features 23
14. Dimensions 24
15. Movement, transport and storage 25
16. Appendix A: MODBUS address.
26
