
Field and Software Tools
CalMaster2 and CheckMaster
3 Installation
10
IM/VCM2
Issue 6
3.2.1 Fitting an Adaptor Board to a MagMaster
To fit an adaptor:
1.
Turn off the power to the MagMaster and remove the covers – see Fig. 3.1.
2.
Remove the wiring from the terminals. Slacken the terminal screws by at least 6 turns.
3.
Carefully ease the sensor wiring to one side and fit the adaptor board so that the extended
pins fit into the terminals – see Fig. 3.2. Tighten the terminal screws.
4.
Fit and tighten the securing screw to the corner of the adaptor board.
5.
Connect the sensor cable leads to the adaptor plug – see Fig. 3.3. Do not fit the plug to the
socket on the adaptor board.
Note.
The newer series (VKH) MagMaster does not need to have this adaptor board fitted as
one is already incorporated into its design.
Fig. 3.2 Fitting the Adaptor Board
Fig. 3.3 Fitting the Sensor Cable Plug
ALARM 1 F OUT A ALARM 2 F OUT B PLS OV PLS OV EXT I/P+ EXT I/P- TX- SIG RX- SIG TX+ SIG RX+ SIG OVC
N
+ L
Adaptor
Board
Pin 1
Pin 8
Pin 7
Pin 6
Pin 5
Pin 4
Pin 3
Pin 2
Pin 1
Grey
Pink
Blue
White
Purple
Bare
Yellow
Red
DS 2
SIG 2
SIG 1
DS 1
SIG GRN
Drain (optional)
CD 2
CD 1
Содержание CalMaster2
Страница 1: ...Instruction Manual IM VCM2 Issue 6 Field and Software Tools CalMaster2 and CheckMaster ...
Страница 49: ...Field and Software Tools CalMaster2 and CheckMaster Notes IM VCM2 Issue 6 47 Notes ...
Страница 50: ...Field and Software Tools CalMaster2 and CheckMaster Notes 48 IM VCM2 Issue 6 ...