ABB AX411, Руководство пользователя

Страница: 6 / 56

4
…2 OPERATION
Available only if the
analog option board is fitted
Dual conductivity only
Key
VIEW SETPOINTS VIEW OUTPUTS VIEW HARDWARE VIEW SOFTWARE VIEW CLOCK
A1: Setpoint Analog Output 1 Sensor A Module AX400/2000 Issue Date01:01:02
A2: Setpoint Analog Output 2 Sensor B Module Time12:00
A3: Setpoint Analog Output 3 Option Board
A4: Setpoint Analog Output 4
A5: Setpoint
Security Code
SENSOR CAL. Cal. User Code Sensor Cal. A
A: Calibration
A: Sensor Slope
A: Sensor Offset
A: Temp. Slope
A: Temp. Offset
A: Reset?
CONFIG.SENSORS Config. Sensor A
A: Cond.Units
A: Cell Constant
A: Temp.Comp.
A: Temp. Sensor
A: Temp.Coeff.
A: TDS Factor
A: TDS Units
Config. Sensor B
B: Cond.Units
B: Cell Constant
B: Temp.Comp.
B: Temp. Sensor
B: Temp.Coeff.
B: TDS Factor
B: TDS Units
CONFIG. DISPLAY
Set Language Set Temp. Units Set Backlight
LED Backlight Temp. Units English
A: Enable Cals.
Use the Sidescroll Key to scroll through the Pages within each Menu
Use the Menu
Key to scroll
through
the Menus
To CONFIG. ALARMS
(see Fig. 2.3B)
Sensor Cal. B
B: Calibration
B: Sensor Slope
B: Sensor Offset
B: Temp. Slope
B: Temp. Offset
B: Reset?
B: Enable Cals.
Use the Downscroll
Key to scroll through
the Parameters
within each Page
OPERATING PAGE
Signal Calc.
After Cat. Limit
Section 2.3, Page 6 Section 3.1, Page 7 Section 3.2, Page 8 Section 3.3, Page 8 Section 3.4, Page 9 Section 3.5, Page 9
Section 4.1, Page 10
Section 5.1, Page 12
Section 5.2, Page 13
Section 5.3, Page 14
Fig. 2.3A Overall Programming Chart