ABB ACS880-M04, Руководство по оборудованию

Страница: 90 / 195

90 Electrical installation

Drive-to-drive link
The drive-to-drive link is a daisy-chained RS-485 transmission line that allows basic
master/follower communication with one master drive and multiple followers. Enable
bus termination on the drives at the ends of the drive-to-drive link. On intermediate
drives, disable bus termination.
The settings for each type of control unit are:
Cables for drive-to-drive connection
• Use shielded twisted-pair cable (~100 ohm, for example, PROFIBUS-compatible
cable) for the wiring. For best immunity, high quality cable is recommended.
• Keep the cable as short as possible. The maximum length of the link is 50 meters
(164 ft).
• Avoid unnecessary loops and running the cable near power cables (such as
motor cables).
• Ground the cable shields as described in section Connecting the control cables –
all frame sizes on page 96 .
Example wiring diagram of drive-to-drive link
Control unit type Switch/jumper
designation Settings
ZCU-14
(frame sizes R1…R4) J3 Termination enabled
Termination disabled
1 2 3 4
B A
BG
N
D
Sh
ie
ld
XD
2D
Termination OFF
1 2 3 4
B A
BG
N
D
Sh
ie
ld
XD
2D
1 2 3 4
B A
BG
N
D
Sh
ie
ld
XD
2D
Termination ON Termination ON