ABB ACS880-1604, Руководство по оборудованию

Страница: 63 / 222

Guidelines for planning electrical installation 63

Minimizing electromagnetic interference
Obey these rules in order to minimize the electromagnetic interference caused by rapid
current changes in the energy storage cables:
•
Shield the energy storage cabling completely, either by using shielded cable or a
metallic enclosure. Unshielded single-core cable can only be used if it is routed inside
a cabinet that efficiently suppresses radiated emissions.
•
Install the cables away from other cable routes.
•
Avoid long parallel runs with other cables. The minimum parallel cabling separation
distance should be 0.3 meters.
•
Cross other cables at right angles.
Keep the cable as short as possible in order to minimize the radiated emissions and stress
on converter IGBT semiconductors. The longer the cable, the higher the radiated
emissions, inductive load and voltage peaks over the IGBTs of the DC/DC converter.

Maximum cable length
The maximum cable length of the energy storage cable(s) is 100 m (328 ft).

EMC compliance of the complete installation
Note: ABB has not verified that the EMC requirements are fulfilled with external energy
storage and its cabling. The EMC compliance of the complete installation must be
considered by the customer.
Protecting the system against thermal overload
For more information on the thermal protection function, see the appropriate firmware
manual.
Protecting the energy storage cable against short-circuits
The DC/DC converter unit must be equipped with DC fuses on the DC bus side and output
DC fuses on the energy storage side. The fuses protect the DC/DC converter and cables
in a cable short-circuit situation.
The customer must equip the energy storage with fuses for protecting the energy storage
cable in a cable short-circuit situation.