Settings, I/O and diagnostics on the control panel 45
Ramps
Use the
Ramps
submenu to set up acceleration and deceleration settings.
Note:
To set ramps, you also have to specify parameter
(in
speed control mode) or
(in frequency control mode).
Constant speeds /
Constant frequencies
These settings are for using a constant value as
the reference. By default, this is set to
On
. For
more information, see
on page
or
Jogging
These settings allow you to use a digital input to
briefly run the motor using predefined speed and
acceleration/deceleration ramps. By default,
jogging is disabled and it can only be used in the
Vector control mode. For more information, see
on page
Run permissions
Settings to prevent the drive from running or
starting when a specific digital input is low.
Menu item
Description
Corresponding
parameter
ACS580 FW.book Page 45 Wednesday, September 21, 2016 9:48 PM
Содержание ACS580 Series
