ABB ACS580-01 drives, Руководство по оборудованию

Страница: 26 / 226

26 Introduction to the manual
Frame (size) Refers to drive physical size, for example R0 and R1. The type
designation label attached to the drive shows the frame of the drive, see
section
Type designation key on page 37 .
FSCA-01 Optional EIA-485 adapter module
I/O Input/Output
IGBT Insulated gate bipolar transistor
Intermediate circuit See DC link .
Inverter Converts direct current and voltage to alternating current and voltage.
Macro Pre-defined default values of parameters in drive control program. Each
macro is intended for a specific application. See
ACS580 firmware
manual (3AXD50000016097[English]).
NETA-21 Remote monitoring tool
Network control With fieldbus protocols based on the Common Industrial Protocol
(CIP
TM
), such as DeviceNet and Ethernet/IP, denotes the control of the
drive using the Net Ctrl and Net Ref objects of the ODVA AC/DC Drive
Profile. For more information, see
www.odva.org , and the following
manuals:
• FDNA-01 DeviceNet adapter module user’s manual (3AFE68573360
[English]), and
• FENA-01/-11/-21 Ethernet adapter module user’s manual
(3AUA0000093568 [English]).
Parameter User-adjustable operation instruction to the drive, or signal measured or
calculated by the drive
PLC Programmable logic controller
PROFIBUS,
PROFIBUS DP,
PROFINET IO Registered trademarks of PI - PROFIBUS & PROFINET International
PTC Positive temperature coefficient (PTC) refers to materials that
experience an increase in electrical resistance when their temperature
is raised.
R0, R1, … Frame (size)
Rectifier Converts alternating current and voltage to direct current and voltage.
SIL Safety integrity level. See chapter Safe torque off function on page 197 .
STO Safe torque off. See chapter Safe torque off function on page 197 .
Term/abbreviation Explanation