ABB ACS380 Series, Руководство по оборудованию

Страница: 75 / 186

Electrical installation 75
Option modules
Typically, option modules are fitted at the factory according to the drive variant or
order.
WARNING! Obey the instructions in chapter Safety instructions on page 13 . If
you ignore them, injury or death, or damage to the equipment can occur.
The drive has two option module slots:
• Front option: Communication module slot under the front cover.
• Side option: Multifunction extension module slot on the side of the drive.
For more information, refer to the option module manual for installation and wiring
instructions. For information on the side-mounted options:
• BTAC-02 pulse encoder interface module on page 153
• BREL-01 relay output extension module on page 171
• BAPO-01 power extension module on page 177
Before you start the work, stop the drive and do the steps in section Precautions
before electrical work on page 15 .

To install a front option
1. Remove the front cover.
2. If you have the BIO-01 option module,
you can add one additional fieldbus
module on top of it. Use the high front
cover.
3. Carefully align the option module with Slot
1 in the front of the drive.
4. Fully push the option module into
position.
5. Push the plastic locking tab until it locks.
6. Tighten the locking screw.
7. Connect the applicable control cables
according to Connecting the control
cables on page 68 .
4
5
6