121
127
AB0A0479
OPT2 kit
128
AB0A0480
Use only in the event of a puncture.
Do not use to inflate tyre that is not
punctured.
remove the cap from the tyre valve
and connect and screw the transparent
tube of the sealant (4) fig. 128 onto
the valve. Make sure that the ON/OFF
button (5) fig. 126 is in the off position
(button not pressed);
plug the electrical connector of the
tyre inflation kit into the 12V socket of
the car and start the engine;
operate the compressor by pressing
the ON/OFF button (5) fig. 126. When
the pressure gauge (7) indicates the
prescribed pressure indicated in
the "Wheels" chapter in this Owner
Handbook or on the label, switch
off the compressor by pressing the
button again and in any case do not
disconnect the hose until the sealing
liquid has been blown in (about 2
minutes);
If the pressure gauge (7) fig. 126
reads a pressure lower than 1.8
bar / 26 psi 15 min. after turning
on the compressor, switch off the
compressor, disconnect the sealant
hose (4) fig. 128 from the tyre
valve proceed with the procedure
for restoring pressure after repair
described in the following paragraph.
Procedure for restoring
pressure after repair
Move the car by approximately 10 m
to allow the distribution of the sealant;
secure the car following the
instructions described in the
"Preliminary operations" paragraph in
this chapter;
restore the pressure using the
black inflation tube (9) fig. 125 for the
OPT1
version or the inflation tube (4)
fig. 128 for the
OPT2
version until
the prescribed pressure is reached. If
also in this case, the pressure is lower
than 1.8 bar / 26 psi 15 minutes after
turning on, do not resume driving but
contact an Abarth Dealership.
Only for
OPT1
: Press the air release
button to adjust any tyre overpressure
(10) fig. 126.
After driving for approximately 8 km
/ 5 miles, repeat the procedure for
restoring the pressure.
For
OPT2
only: This can only be used
to restore pressure after using the kit
to repair a puncture (i.e. with empty
sealing cartridge)
WARNING
138)
The information required by the
applicable regulation is indicated on the
Fix&Go kit package label. Carefully read
the label on the cartridge before use, avoid
improper use. The kit should be used by
adults and cannot be used by children.
139)
IMPORTANT: Do not exceed
80 km/h. Avoid sudden acceleration or
braking. The kit provides a temporary
repair, therefore the tyre must be
examined and repaired by a specialist as
soon as possible. Before using the kit,
ensure that the tyre is not excessively
damaged and that the rim is in good
condition, otherwise do not use it and
call roadside assistance. Do not remove
Содержание 595
