Aastra 470, Руководство по установке, Страница: 13 / 22

Configuring the application card
13
Applications Card CPU2
syd-0421/1.2 – R2.1 – 07.2012
Configuring the application card
Configure the applications card by executing the configuration processes in
the following order:
Basic configuration , IP Network and Licenses . Then
configure the OIP and TWP applications. To secure the configuration data,
create a backup in the end.
Settings under Basic configuration
The general settings are described below.
Basic configuration
Parameter Explanation
Company name Enter the customer's company or organisation name here.
Name sequence (as recorded in
the communication server). Define the order of first name and surname here. The setting is applied to all
applications of the applications card. Select the same order as defined in the
communication server’s phone books.
Note:
Perform this setting at the beginning of the configuration process and, if
possible, do not modify the setting in a fully configured system.
Use DNS server name in LAN (if
available) Choose this option if a DNS server is set on your IP network.
IP address Communication server IP address
If the wrong IP address is entered, the setup wizard has probably detected
other communication servers on your subnet. You can see all the IP addresses
of detected communication servers under
Found communication server .
Choose the IP address of the right communication server and click the button
<< , to confirm it.
Communication servers in
subnet List of the IP addresses of all detected communications servers on the subnet.
To use any of the IP addresses, click the
<< button.
Old password The application card current password used for the Windows operating
system as well as on the installed OIP and TWP applications.
New password The application card new password is automatically used for the Windows
operating system on the application card as well as on the installed OIP and
TWP applications. To change the password may takes several minutes.
Windows work group settings These settings are only relevant if the application card is to be integrated into
a Windows work group.
Note:
The application card can be used in a domain environment, but should not
be a member of a domain.
CTI server configuration portals In this section, you will find a link to the OIP toolbox and a link to the TWP
configuration page. Log on using the username
cpu2-emmc and the
application card password.