To program the Time and Date:
Press the UP and DOWN buttons to get to the correct num-
ber and the DELETE button to accept.
NOTE
: You may not have to set up the Time
and Date manually as it may be auto-
matically updated by Call Display infor-
mation when your phone rings (twice or
more). To get back to the standby mode
(for dialing), press the DELETE button
until the normal display shows (see right for example).
Adjusting the LCD Contrast Level
You can also adjust the grey-level of the display without enter-
ing the initial setup mode. Hold the DELETE button, then
press the CALL BACK button to enter the LCD CONTRAST
level setting mode. Use the UP or DOWN button to select the
suitable grey-level and press the DELETE button to accept.
BASICS
Choosing Tone or Pulse Dialing
Select the type of dialing by setting the TONE/PULSE switch.
If you are not sure of your dialing system, make a trial call
with the switch set to TONE. If the call connects, leave the
switch as it is; otherwise, set it to PULSE. Even when your
phone is set to pulse service, this phone can be switched to
temporary tone for access to services that require tone sig-
naling including Telephone Banking. Just press the TONE
button after dialing in pulse and your buttons can now be
used for tone signaling for this call only.
5
SET HOUR
10:00 - 0/0
SET MINUTES
10:53 - 0/0
SET DATE
10:53 - 0/18
SET MONTH
10:53 - 6/18
TOTAL 00 NEW 00
10:53 - 6/18
(Example: 10:53 a.m.
on June 18th)
