AAS PhoneAire 16-1050, Инструкции по установке и программированию

Страница: 16 / 20

16
Double beep = disabled
Notes:
1) Pressing * will clear the phone number digits entered.
2) Pressing # will “enter” the phone number. A good beep will sound if 7, 10, or 11 digits have
been entered when # is pressed. If not, a bad beep will sound and call forwarding will be
disabled if it was enabled.
3) Digits can be entered until # is pressed. Any digits over 11 will be discarded and a bad
beep will sound when # is pressed.
4) Call forwarding can only be enabled when there has been a valid phone number entered.
Sub-Mode 5 (Set One Shot Code)
EXPLANATION: This Mode is used to program a one-shot code, and to enable it or disable it.
After the 5 is pressed the enable/disable status is heard (one beep = enabled, two beeps =
disabled) followed by a GOOD BEEP.
To disable the one-shot code enter:
(MASTER CODE) + 5 (*status) + 0
To enable the one-shot code enter:
(MASTER CODE) + 5 (*status) + 1
To change the one-shot code enter:
(MASTER CODE) + 5 (*status) + 2 + (ONE-SHOT CODE)
To change the relay the one-shot code activates enter:
(MASTER CODE) + 5 (*status) + 3 + (RELAY #)
The Relay # corresponds to which relay to set. 1 = Relay A, 2 = Relay B.
Sub-Mode 6 (Set Relay Output Times)
To set or change a relay output time enter the following;
(MASTER CODE) + 6 + (RELAY #) + (RELAY OUTPUT TIME) in seconds
The Relay # corresponds to which relay to set. 1 = Relay A, 2 = Relay B. Should you make a
code entry error, simply press the * key and enter the correct code. Your output time is set on
both relays from the factory at approximately 1/2 seconds "00". If a longer output time is
desired, enter a two digit number corresponding to the number of seconds between "00" and
"99". By entering "00" the output time is set to approximately 1/2 seconds which is ideal for
most operators.
Sub-Mode 7 (Program Relay B Access Codes)
To program new Relay B access codes enter the following;
(MASTER CODE) + 7 + (NEW CODE) + (NEXT NEW CODE) etc......... ( # to exit)
Should you make a code entry error, simply press the * key and enter the correct code. You
may select any 4 digit code you wish. If you receive an ERROR after entry, you must select
another code as it is already in use. The unit will respond with a GOOD BEEP with the
acceptance of each new Relay B code. You may continue entering Relay B codes until you
finish (Press #), or the memory becomes full. You will automatically be exited from the