AAS PhoneAire 16-1050, Инструкции по установке и программированию

Страница: 14 / 20

14
Sub-Mode 1 (Program Relay A Access Codes)
To program new Relay A access codes enter the following;
(MASTER CODE) + 1 + (NEW CODE) + (NEXT NEW CODE) etc......... (
#
to exit)
Should you make a code entry error, simply press the
*
key and enter the correct code. You
may select any 4 digit code you wish. If you receive an ERROR after entry, you must select
another code as it is already in use. The unit will respond with a GOOD BEEP with the
acceptance of each new Relay A code. You may continue entering Relay A codes until you
finish (Press
#
), or the memory becomes full. You will automatically be exited from the
program mode if the memory reaches capacity. When memory is full you will not be able to
enter this Sub-Mode and will receive an ERROR if entry is attempted.
Sub-Mode 2 (Delete Codes)
To delete codes enter the following;
(MASTER CODE) + 2 + (CODE TO BE DELETED)
Should you make an entry error, simply press the
*
key and enter the correct code. You may
delete any access or function code that you wish with the exception of the MASTER CODE. If
the code you wish to delete is not found in memory, the unit will respond with an ERROR and
wait for another code to be entered. A GOOD BEEP will be sounded once the code has been
found and deleted. You may continue deleting codes until you finish (Press #).
Sub-Mode 3 (Change Master Code)
To change your master code enter the following;
(present MASTER CODE) + 3 + (new MASTER CODE)
Should you make a code entry error, simply press the
*
key and enter the correct code. You
may select any 4 digit master code you wish. If you receive an ERROR, you must select
another code as it is already in use. The unit will respond with a GOOD BEEP with the
acceptance of the new Master Code and you will be exited from the program mode. MAKE
SURE TO WRITE THE NEW MASTER CODE DOWN.
Sub-Mode 4 (Set Sleep Code & Latch Code and/or Call Forwarding)
EXPLANATION: The sleep code used to disable all Relay A and function codes from the
keypad. It also turns shuts off the CALL button on the intercom. This feature is most
commonly used in applications where no entry is desired after hours. Relay B codes will still
be valid from the keypad. By connecting both relays in parallel, managers may be assigned
RelayB codes and still gain access. While in the SLEEP MODE, the yellow and red LED's will
flash approximately once every 3 seconds. To initialize the system back to normal, simply re-
enter the sleep code. Should you lose or forget your sleep code and the unit is in the sleep