AAS PhoneAire 16-1050, Инструкции по установке и программированию

Страница: 12 / 20

12
unit will be enabled. An override code is provided.
“ONE SHOT CODE”
This code is a programmable four digit code that disables itself after
one use. The user can enable this code for reuse using the keypad
or telephone.
GOODBEEPS & ERRORBEEPS
Your unit will beep each time a key is pressed. The "*" key serves as the clear key and a
double beep will be heard when this key is pressed. A "GOODBEEP" is represented by an
oscillating high tone. An "ERROR BEEP" is represented by a single low tone.
THE RED & YELLOW LED's
Two different colored LED's are in the face of the unit. The red LED will light during the
duration of the relay(s) activation period. The yellow LED will light while the unit is in the
program mode. During memory erasure or setup the LED's will flash.
RESETTING THE UNIT
Your unit provides 2 different types of resets, a Unit Reset, and a Master Reset.
A Master Reset should be utilized in the event that you lose or forget your master code or if
the unit is in the Latch or Sleep mode and the Latch or Sleep code is lost or forgotten. When
a Unit Reset is performed, the master code will be set back to 1 2 5 1.
A Unit Reset is provided should it ever become desirous to reset the unit back to the initial
factory state. After a Master Reset has been performed the unit will DELETE ALL ACCESS &
FUNCTION CODES and the master code will be set back to 1 2 5 1.
MASTER RESET
Follow these steps precisely. If you make an error, the unit will ERROR and you will have to
start over.
Press and hold down SWRESET button. Press and release HWRESET button. Unit will beep
continually. Press *** on keypad. Press and release HWRESET button.
The unit will issue a good beep and the master code will be set back to 1 2 5 1. If you
previously were in the sleep or latch mode, the unit will be brought back to idle state.
UNIT RESET
(!!!!! WARNING: ALL CODES WILL BE DELETED FROM MEMORY !!!!!)
* (Please See pg. 6 for further information)
Follow these steps precisely. If you make an error, the unit will ERROR and you will have to
start over.
Press and hold down SWRESET button. Press and release HWRESET button. Unit will beep
continually. Press *** on keypad. Press and release HWRESET button.
Release HWReset button & enter # * # (The unit will respond with a GOOD BEEP)
Enter 1251 from the keypad. (The unit will flash the LED's several times and then go into an
endless cycle of beeps)