“4”
Sub-Mode 4 (Set Relay Output Time from 1/2 to 9 seconds
To set the relay output time in seconds enter the
PRESENT MASTER CODE, followed by 4, and then the relay output time in seconds. NOTE: “0” = 1/2
seconds.
(PRESENT
MASTER
CODE)
then 4 then (RELAY OUTPUT TIME)
Should you make an entry error, simply press the * key and re-enter the correct data. You may enter any single
digit value corresponding from 1/2 to 9 seconds of total length output time. Please note that when you enter “0”,
the output time is set to 1/2 seconds.
“0”
Sub-mode 0 (Clear memory) !!!! WARNING ALL ACCESS CODES WILL BE DELETED !!!!
To delete all access codes from memory enter the MASTER CODE, followed by 0, and the re-enter the
MASTER
CODE.
(MASTER CODE) then 0 then (MASTER CODE)
Should you make an entry error, simply press the * key and re-enter the correct data. If the second entry of the
master code is correct there will be a short pause before a GOODBEEP is heard and then the unit will
automatically be exited from the program mode. If the second entry of the master code is incorrect, the unit will
still respond with a GOODBEEP indicating that it is exiting the program mode however, there will be no pause
on the GOODBEEP and the memory will not be erased.
NOTE: It should not generally be necessary to erase all access codes from memory unless codes are
forgotten and are occupying necessary memory space. A good log and maintenance of access codes
should prevent this from ever needing to be done.
DKW CIRCUIT BOARD DIAGRAM
Part # 30-017A-100
PROGRAM/RESET BUTTON
MICROROCONTROLLER
POWER/CONTROL
HARNESS
(JP1)
RELAY
7
