AAON RZ Series, Установка, эксплуатация и обслуживание

Страница: 27 / 112

27
Codes and Ordinances
The RZ Series has been tested and certified
by Intertek (ETL) to the following safety
standards:
ANSI Z21.47-2016/CSA 2.3-2016
Gas-Fired Central Furnaces
ANSI Z83.8-2016/CSA 2.6-2016
Gas unit heaters, gas packaged heaters, gas
utility heaters and gas-fired duct furnaces
UL 1995/CSA C22.2 No. 236-11 Fourth
Edition
Heating and Cooling Equipm ent
System must be sized in accordance with
practices described in the American Society
of
Heating, Refrigeration, and Air
Conditioning Engineers Handbooks.
AAON equipment must be installed in
accordance with this manual and the
International
Code Council (ICC)
requirements.
Installation of RZ Series units must conform
to the International Code Council (ICC)
standards of the International Mechanical
Code, the International Building Code, and
local building, plumbing, and waste water
codes. In the absence of local codes
installation must conform to current National
Fuel Code ANSI Z223.1/NFPA 54 or the
National Gas & Propane Installation Code
CSA B149.1, and CSA B52 Mechanical
Refrigeration Code. All appliances must be
electrically grounded in accordance with
local codes, or in the absence of local codes,
the National Electric Code, ANSI/NFPA 70,
and/or the Canadian Electrical Code CSA
C22.1.
Receiving Unit
When received, the unit must be checked for
damage that might have occurred in transit. If
damage is found, it must be noted on the
carrier’s Freight Bill. A request for inspection
by carrier’s agent must be made in writing at
once. Nameplate must be checked to ensure
the correct model sizes and voltages have
been received to match the job requirements.
If repairs must be made to damaged goods,
notify the factory before any repair action is
taken in order to protect the warranty. Certain
equipment
alteration, repair, and
manipulation of equipment without the
manufacturer’s consent may void the product
warranty. Contact the AAON Warranty
Department for assistance with handling
damaged goods, repairs, and freight claims:
(918) 382-6450.
Note: Upon receipt check shipment for items
that ship loose such as filters and remote
sensors. Consult
order and shipment
documentation to identify potential loose -
shipped items. Loose-shipped items may
have been placed inside unit cabinet for
security. Installers and owners must secure
The Clean Air Act of 1990 bans the
intentional venting of refrigerant as of
July 1, 1992. Approved methods of
recovery, recycling, or reclaiming
must be followed.
CAUTION
Failure to observe the following
instructions will result in premature
failure of your system and possible
voiding of the warranty.
WARNING
Coils and sheet metal surfaces
present sharp edges and care must
be taken when working with this
equipment.
WARNING