5. Insert Pin at end of Wand through hole in Outer Arm so
It aligns Foot for easy storage. Fig. 5A. Swing Arm up
to Case. Fig. 5B. Slide Arm and Foot away from center
of Case so foot can be inserted into center section of
awning Case. Fig. 5C.
Repeat for other side.
TO CLOSE ON CURVED SIDED VEHICLE
6. IF AWNING IS SET IN PATIO POSITION:
A. Remove Spikes from awning Foot.
B. Attach Foot to Bottom Mounting Bracket on side of
vehicle to set awning into Pivot Position. Fig. 6.
Repeat for other side. Then proceed to Step 7A.
7. IF AWNING IS SET IN PIVOT POSITION
A. Firmly grasp Pull-Strap and loosen Lock Knobs.
Fig. 7A.
While tightly holding Pull-Strap pull on Strap to
relieve pressure from Rafter Lock Buttons and push
Rafter Lock Buttons in to unlock rafters (Fig. 7B)
and allow awning to roll up until awning extends
approximately two feet from awning Case.
Tighten Lock Knobs on both Rafter Arms.
B. Release foot from Bottom Mounting Bracket. Figs.
7C and 7D.
Loosen Lock Knob and lower Arm Assembly verti-
cally to ground. Fig. 7E. With Foot still on ground
raise Inner Arm until Roller Tube is slightly above
awning Case, then tighten Lock Knob.
Repeat for other side.
ARM ASSEMBLY
EXTENDED
7G
SIDE VIEW
7H
ARM I
ASSEMBLY
C. Place awning Feet directly below the awning Case.
D. While firmly holding the Pull-Strap loosen Lock
Knobs on Rafter Assembly and allow awning to
close. Fig. 7F.
NOTE: Do not release Pull-Strap until awning has com-
pletely rolled up.
NOTE: The “D” Ring on Pull-Strap must remain outside
awning case.
7
NOTE: Make sure Lock in top of awning Arm Assembly
clears top of Case Lip. Fig. 7G. If Lock does not clear
Case Lip, raise Arm height until Lock clears Lip. This is
necessary for proper operation of awning Case Locks.
E.
Loosen Lock Knob on Arm Assembly. Fig. 7H.
Repeat for other side.
AWNING CASE
8. Insert Pin at end of Wand, through hole in Outer Arm so
it aligns Foot for easy storage. Fig. 8A.
Swing Arm up to Case. Fig. 8B. Slide Arm and Foot
away from center of Case so Foot can be inserted into
center section of awning Case. Fig. 8C.
Repeat for other side.
