Tighten Lock Knob.
Repeat Steps 4B. & 4C for other side.
4D
AWNING
NOTE: Make sure Lock in top of awning Arm Assembly
clears top of Case Lip. Fig. 4C.
This is necessary for awning to open properly.
PULL-STRAP
C. Using Wand, hook Pull-Strap and pull awning out
about 3 feet (1 meter). Fig. 4D.
D. While securely holding the Pull-Strap, tighten the
Lock Knobs on the Rafter Arms. Fig. 4E.
5
BRACKET
5.
Snap awning Foot in Bottom Mounting Bracket. Fig.
5.
6.
Select a location for mounting of Bottom Mounting Bracket
on side of vehicle.
The minimum
distance from
the bottom of the awning
Case to the bottom of the Bottom Mounting Bracket for
the 2.5 meter awning is 122 cm; for the 3.0, 3.5 and 4.0
meter awnings it’s 147 cm. Fig. 6.
5
AWNING CASE I
NOTE: Positioning of Left and Right Bottom Mounting
Brackets should be at same level and centered to the
awning arms. Fig. 6.
7. Loosen Lock Knob and extend Arm Assembly keeping
arm perpendicular to vehicle. Once location is deter-
mined, tighten Lock Knob. Fig. 7.
PAN HEAD
BOTTOM
MOUNTING
BRACKET
9A
#10 * 1”
PHILLIPS
PAN HEAD
BOTTOM
MOUNTING
BRACKET
NOTE: The Bottom Mounting Brackets should be
mounted to the floorline of solid structural member
whenever possible.
a.
Using the Foot and Bottom Mounting Bracket as a
template, drill a 1/8”(3mm) Dia. hole for the bottom
screw. Secure Bottom Mounting Bracket with Foot
attached, to vehicle using a # 10x1 -1/2" long Phillips
Pan Head Sheet Metal Screw through the Foot and
Bottom Mounting Bracket. Use a small dab of
Silicone Sealant on screw. Fig. 8.
9. A. Release Foot from Bottom Mounting Bracket
and drill a 1/8”(3mm) Dia. hole for the top
screw. Using a # 10x1” long Phillips Pan Head
Sheet Metal Screw with a dab of Silicone
Sealant on it, secure the top of the Bottom
Mounting Bracket to vehicle. Fig. 9A.
Repeat Steps 5 through 9A for other side.
9C
SIDE VIEW
B. Loosen Lock Knob and lower Arm Assembly to
ground. With foot still on ground raise Inner Arm as
high as it will go. Fig. 9B.
NOTE: Make sure Lock in top of awning Arm Assembly
clears top of Case Lip. Fig. 9C.
Tighten Lock Knob.
Repeat Step 9B for other side.
3
