A&D TM-2564G, Инструкция по эксплуатации

Страница: 55 / 62

44
7-3 Assembling the Cuff
Replacing the cuff cloth
Insert the rubber hose completely into the cuff cloth. From the
bladder opening, pull out the bladder with the rubber
hose.
After replacing the cuff cloth, put back the bladder and
the rubber hose through the bladder opening. Pull out
the rubber hose through the rubber hose opening.
Be sure to pull out all of the rubber hose. Otherwise, when
pressurized, the bladder may inflate at the opening and
burst.
7-4 Disposing of the Instrument
When recycling or disposing of the instrument, follow the local regulations.
Battery
When disposing of the used battery, insulate the battery lead connector with tape and follow the local
regulations.
Cuffs and sensors
The cuffs and sensors used by the patient may cause infection. Dispose of them as medical waste.
Built-in lithium battery
When disposing of the instrument, remove the built-in lithium battery.
When disposing of the battery, insulate it with tape and follow the local regulations.
7-5 Before Asking for a Repair
Before asking for a repair, check the instrument error codes in "7-6 Error Codes" or read "Appendix A:
Measuring Principle" to see whether the measurement was performed correctly.
If normal operation of the instrument cannot be recovered even after these actions have been taken,
contact the agent where you purchased the instrument or the nearest A&D sales representative.
Caution
Only qualified service personnel are allowed to open the case to repair the instrument.
Do not attempt to open the instrument.