A&D TM-2560G, Инструкция по эксплуатации

Страница: 24 / 62

13
4-3 Installation Procedure
Warning
•
Do not use damaged cables and sensors.
•
Use the specified cables and sensors only.
•
The ECG unit is protected against defibrillator discharge only when the
supplied ECG extension cable is used.
1. Confirm that the power switch is turned
off.
2. Connect the cuff hose to the CUFF
connector of the instrument. Use the
1.5-m hose to extend it, if necessary.
3. Connect the SpO
2
extension cable to the
SpO
2
connector of the instrument and
lock it.
4. Connect the SpO
2
cable to the SpO
2
extension cable.
5. Connect the ECG extension cable to the
ECG connector of the instrument.
Confirm that it is securely connected.
6. Connect the ECG patient cable to the
ECG extension cable.
4-4 Printer Paper Loading Procedure
1. Press the printer cover open switch to
open the printer cover.
2. Load the printer paper as shown in the
illustration, and close the cover.
3. Press the FEED key to check that the
paper is fed properly.
4. Cut the leading edge of the printer paper
at a right angle.