![background image](http://html2.mh-extra.com/html/aandd/tm-2430/tm-2430_instruction-manual_3078882035.webp)
Page 33
Maintenance
Error Code
Error
code
Meaning
Status
Operation and Treatment
E30
E31
E32
E50
E52
E53
E55
E56
E57
E60
E70
E71
E72
E73
E74
E75
E90
E91
Other
Air is exhausted from the
cuff, and an error code is
displayed.
Air is exhausted from the
cuff, and an error code is
displayed.
An error code is displayed.
An error code is displayed
at restarting the product.
An error code is displayed
at restarting the product.
The measurement is
stopped, air is released
from the cuff and an error
code is displayed.
An error code is displayed
at measurement.
Start time is not proper,
interval of last block is not
set in the unit of 120 min.
The error code is displayed
during communications.
This error code is
displayed before the
measurement.
Patient moved during the
measurement.
Monitor code is displayed.
Repair is necessary because of slow
inflation or slow constant exhaust.
Repair is necessary because of slow
constant exhaust.
If you not clear this error, the product
needs repair.
Release the air from the cuff com-
pletely, reset the product. If you not
clear this error, repair is necessary.
The product needs repair.
Replace batteries correctly. If you can
not clear this error, the product needs
repair.
Relax and do not move during the
measurement. If this error occurs
many times, repair is necessary.
Enter parameters for the interval
correctly.
Re-connect the communication cable.
If you can not clear this error, the
product needs repair.
Replace batteries with new ones and
restart communication.
Re-connect the communication cable.
If you can not clear this error, the
product needs repair.
Release the air from the cuff
completely.
Relax and try to quiet during the
measurement. If it occurs in quiet, the
recorder needs repair.
Reset. Turn on power switch again.
Measurement is
greater than 120
seconds.
The constant
exhaust is greater
than 60 seconds.
Clock error.
Pressure offset
error to measure
pulsation.
Memory error.
Battery contact is
defective.
Exhaust error.
Interval setting
error.
RS-232C error.
Low battery for
communication.
Protcol error due
to external
equipment.
Pressure zero
error for safety
circuit.
Safety circuit
detects over load
pressure.
Содержание TM-2430
Страница 36: ...Page 34 MEMO...