A&D MF-50, Инструкция по эксплуатации

Страница: 27 / 74

MS-70 / MX-50 / MF-50 / ML-50 25
6.3. Program Number
The measurement conditions of all program numbers are set to the standard mode at the
factory. The analyzer can store and recall proper individual settings for each sample with
the program number (PROG No.).
MS-70 / MX-50 20 sets PROG 1 to 20
MF-50 10 sets PROG 1 to 10
ML-50 0 5 sets PROG 1 to 5
The same measurement program is stored in all program
numbers with factory settings.
Analysis mode..................... Standard mode
Heating pattern ................... Standard drying
Caution If the data memory function is active, the data memory number (MEM) is
displayed, in place of the program number (PROG).
6.3.1. Storing a Measurement Program to a Program Number
Displaying or recalling a PROG number, a measurement program can be renewed.
1. Press and hold the
PROGRAM
key in gram display.
2. Press the
↓
or
↑
key to select a program number
3. Press the
ENTER
key to use the selected number.
4. Press the
SELECT
key to edit the parameters.
5. Edit parameters of a measurement program.
Refer to "7.Selection of Measurement Method"
6. Press the following key to return to the gram display.
ENTER
key......Stores parameters to the selected number.
RESET
key......Cancels the operation and returns to the
weighing mode.
6.3.2. Recalling a Measurement Program with a Program Number
Stored measurement programs can be recalled with a program number.
1. Press and hold the
PROGRAM
key in the gram display.
2. Press the
↓
or
↑
key to select a program number
3. Press the
ENTER
key to use the selected number.
Program number
Memory number
PROG
"1
0.000
g
PROG "2
end
PROG 2
0.000
g
Program number
Edit measurement
program.
end
PROG 2 0.000
g
PROG "1 0.000
g
PROG "2
end
PROG "2 0.000
g
Program number