MC-2000, Version 2.6
I:MAN-MC2000USA
5
Maximizing Money Count Performance
Environment
:
The MC-2000 is calibrated & ready for use when unpacked. Always follow
the instructions in “Getting Started” Section on page 2.
Money Count Accuracy
Silver Coins: nickels, dimes & quarters (loose or rolls) are no problem in any environment.
Pennies: difficult to guarantee because average piece weights vary greatly. Our tests suggest
that you will typically be within 2 cents per 100. Penny Roll accuracy is no problem.
Paper Currency: $1s & $5s are the most difficult because they tend to circulate more fre-
quently, getting the most wear. Also,
all
bills will absorb moisture from humidity or steam,
which adds weight that
may
reduce counting accuracy. The Factory setting of F10 restricts
placing more than 40 bills on the scale at one time to overcome the inconsistent weights of
paper money, hence maximizing accuracy. This value of 40 can be altered to your personal
environment or completely disabled. In ideal environments, it is not uncommon for the MC-
2000 to accurately count 100s of bills when placed on the scale all at once. Although operating
speed is slightly increased, risk of innaccurate count is also increased.
Basic gram (g) and ounce (oz) Weighing Operation
1. Press
MODE
to select unit of measure.
2. Before weighing an item, make sure the scale shows a zero weight indication. If not, re-
move all items from the platter and press
ZERO
key.
3. Place the item on the scale’s platter and allow the weight indication to stabilize.
4. To add weight value to accumulator, press
ADD
. (Value also prints.)
5. To display accumulator at any time (for 3 seconds), press
TOTAL
.
6. To clear accumulator and print total, press/hold
ZERO
, then press
TOTAL
.
Basic Counting (pcs) Operation
1. Before weighing an item, make sure the scale shows a zero weight indication. If not, re-
move all items from the platter and press
ZERO
key. If using a container, place empty
container on scale and press
ZERO
.
2. Press
MODE
until “5 0 pcs” is displayed. To change sample size from 5 /10 / 20 / 50,
continue to press
Sample
.
3. Place selected number of samples on the scale platter and allow the weight indication to
stabilize. “5 – pcs” is now displayed. Press
Enter
. “5 pcs” is now displayed and you can
continue to count. If “Lo” is displayed, sample size is too small and will advance to next
largest sample size. Add additional samples to equal the value on the display. Press
Enter
again.
4. To add count value to accumulator, press
ADD
. (Value also prints.)
5. To display count accumulator at any time (for 3 seconds), press
TOTAL
.
6. To clear count accumulator and print total, press/hold
ZERO
, then press
TOTAL
. To
determine a new APW, press
MODE
.
