Aamstamp AAMStamp Sprite, Инструкция по эксплуатации

Страница: 7 / 20

6
LOADING FOIL
Remove the rear foil dereeler spool from the rear foil bracket by opening the brass
tension springs on both sides of foil bracket. The rear spool has markings used to
center 2, 3, 4 and 5 inch foil rolls. Slide the roll of foil onto the spool and put it back on
the foil bracket so that the foil feeds from the top of the roll and toward the operator.
Feed your foil under the foil guide bars and attach foil to the front foil take up spool with
a small piece of tape. Replace the spool on the front foil take up bracket. Foil color
should face up.
MANUAL FOIL ADVANCE KNOB
The foil advance knob is located on the left side of the front foil take
up spool and is 1 3/4” in diameter. To adjust your foil simply turn
the knob counter-clockwise between each print. Check to make
sure you that you pulled the used foil past the typehead, so that
during the next print there will be new unprinted foil underneath it.
SPRITE DIAGRAM
Foil Dereeler Spool
On/Off
Temperature
Control Knob
Power On Light
Foil Take-up Spool
Foil Advance Knob
Foil Guide Bars