Aamstamp AAMStamp Sprite, Инструкция по эксплуатации

Страница: 10 / 20

9
THE 10 X 12 BASE PLATE
The AAmstamp 10x12 Ribbon and Stationary Plate offers you the most flexibility in printing
ribbon and stationary. This plate is commonly used for printing ribbon(Ribbon guides sold
seperatly) or stationary such as business cards, postcards, greeting cards and objects such as
photo albums, folders and portfolios.
Setup Instructions for printing ribbon
Ribbon guides optional on base plate.
1.
Slide the 10x12 plate over the table plate of the sprite and push it all the way to the back.
Then lock the plate in place using the clamp knob on the top-right side of the 10x12 plate.
2. When printing ribbon you should remove the side adjustment plate from the 10x12 base plate.
3.
Load the ribbon onto the AAmstamp Ribbon Spindle. Place the ribbon spindle to the right
side of the 10x12 base plate so that the ribbon can be easily fed through the plate.Ribbon
Spindle sold seperatly.
4.
Loosen all four of the ribbon guide slider adjustment knobs located on the bottom side of the
10x12 plate. Ribbon guide attachment sold seperatly.
5.
Feed the ribbon through the 10x12 plate. Feed the ribbon from underneath the main base
plate and bring it up through the open slot on the right hand side, then continue across the
cushion board and then down through the slot on the left hand side.
6.
Now bring the top and bottom sliders on both sides of the 10x12 plate down to meet your
ribbon. Check the location of the ribbon to be sure that the your print will be centered on the
ribbon by pulling the machine operating handle down while lining up the ribbon. Make sure
that both sides of the ribbon are even by lining it up against the incremental marks engraved
on the main plate.
7.
Tighten the ribbon guide slider adjustment knobs. SETUP COMPLETE.
Setup Instructions for printing stationary, books and albums:
1.
Slide the 10x12 plate over the table plate of the machine. You can either align the vertical
position by eye or use the formula: PAGE 1/2” (STOP RULER) + (PRINT
HEIGHT / 2). Lock the 10x12 plate in place using the clamp knob on the top-right side of the
plate.
Attach the side adjustment plate to the right or left side of the 10x12 plate. This plate acts as
2.
a right hand or left hand stop when printing stationary products. If you would like to center
your print, divide the width of your product in half and align the side adjustment plate to that
location using the stop ruler on the top of the 10x12 plate. For example if you are trying to
center an 8.5” wide sheet of paper you would set the side adjustment plate to 4.25”.
SETUP
COMPLETE.
Stationary Stop Guides
Stop Ruler
Side Adjustment Plate
Side Plate
Adjustment Knob
Clamp Knob
Ribbon Slot
Main Plate
Cushion Board