Troubleshooting
and FAQ
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Rev: V.01
Date: 031919
Page 1
SWI-RC-1
Steering Wheel Control Interface
Q.
Where can I find the wiring info to connect the SWI-RC-1 to my vehicle?
A.
The wiring info can be found on our website @ www.pac-audio.com/swi-rc-1
Q.
Where can I find info on setting the DIPswitches on the side of the module?
A.
The DIPswitch settings can be found on our website @ www.pac-audio.com/swi-rc-1
Q.
The module’s LED is flashing a pattern that is not consistent with normal operation.
A.
Please reference the LED legend above for your specific case.
Q.
Is there a way to perform a master reset to the module?
A.
The interface can be reset,
when not connected via USB
, by pressing and holding the programming
button on the side of the interface for seven seconds until the LED turns amber.
This reset can only be
done while the module is connected to the vehicle
.
Q.
I have connected all of the wires and set the DIPswitches as instructed. I am having an issue where some or
all of the buttons are not functioning correctly or at all.
A.
Verify that all of the ground wires (Radio, SWI-RC-1, and steering wheel circuit) are connected at the same
place. In some vehicles the factory ground may not be a sufficient ground for all of these wires. In this case
please make all ground connections to chassis ground.
Q.
I’m looking at your website and I don’t see my radio listed (Advent, Boyo, Dual, Lightning Audio, Rockford
Fosgate or Visteon).
A.
When installing any of these brands you will need to select Pioneer as your radio.
Color
During
Normal
Operation
During
Manual
Programming
Mode
During
Optional
Programming
Solid
Red
Accessory
on
Waiting
on
short
press
button
release
Waiting
on
short
press
button
release
Solid
Green
N/A
Waiting
on
button
to
be
pressed
Waiting
on
button
to
be
pressed
Solid
Amber
Update
required
‐
Please
call
tech
support
N/A
N/A
Flashing
Green
Button
is
being
pressed
N/A
N/A
Flashing
Amber
every
5
seconds
Module
is
connected
to
the
PC
via
USB
N/A
N/A
Flashing
Red/Amber
Error
‐
Dipswitch
setting
on
vehicle
switches
set
to
unknown
config
Long
Press
Button
detected
Long
Press
Button
detected
Flashing
Green/Red
Error
‐
Dipswitch
setting
on
radio
switches
set
to
unknown
config
N/A
N/A
Flashing
Green/Amber/Red
Error
‐
Button
not
pressed
long
enough
or
value
of
button
is
too
close
to
rest
value
N/A
N/A
LED
Legend
