Aalborg DPM Series, Руководство по эксплуатации

Страница: 19 / 111

17
The main DPM flow meter screen shows current instrument Pressure, Temperature,
Mass Flow, and Totalizer Volume readings in previously selected units of measure.
6..2 2 S Sw wa am mp piin ng g C Co on nd diittiio on
If a flow of more than 133% the nominal maximum flow rate of the Mass Flow
Meter is taking place (displayed mass flow reading is flashing), a condition
known as "swamping" may occur. Readings of a "swamped" meter cannot be
assumed to be either accurate or linear. Flow must be restored to below 133%
of maximum meter range. Once flow rates are lowered to within calibrated
range, the swamping condition will end.
22.67
PSIA
27.7
C
0.00
T1: 14726.0 Sml
Sml
min
Figure 6: DPM Initial Process Information
Absolute Pressing
Reading
Current Mass Flow
Rate Reading
Totalizer #1 Reading
Temperature
Readin
g
Current Unit of
Measure for
Mass Flow
Totalizer#1
Units of
Measure
NOTE:
Actual content of the OLED screen may vary depending on
the model and device configuration.
NOTE:
5 seconds after the initial powering of the DPM flow meter,
the status LED will emit a constant GREEN light (normal operation,
ready to measure).
Fiigguurre 44:: DPPM M firrsst BBaannnneerr SSccrreeeenn
Fiigguurre 55 :: DPPM M FFiirrm mw waarree aannd CCoom mm muunniiccaattiioon IInntteerffaaccee IInnffoormation SSccrreeeenn
FFw w: AA000011 TTbbll:: AA000011
CCO OM M::R RSS22332 AAdddd:: 1111
BBaauudd R Raattee: 99660000
M MooddBBuuss: Y AAdddd:: 1111