Aaeon PCM-6892 Rev.B, Руководство пользователя

Страница: 30 / 99

2 0 PCM-6892 Installation Guide
BC-
PCM-6892
Front Panel Connector (CN6)
Pin Signal Pin Signal
1 GND 2 PWBT#
3 HDDLED# 4 VCC +5V
5 BEEPR 6 VCC +5V
7 GND 8 PWLED
9 GND 10 RSTIN#
IDE Hard Drive Connector (CN9)
You can attach two Enhanced Integrated Device Electronics hard
disk drives to the PCM-6892's internal controller.
Connecting the Hard Drive
Wire number 1 on the cable is red, and the other wires are gray.
1. Connect one end of the cable to the IDE connector and make
sure that the red wire corresponds to pin 1 on the connector,
which is labeled on the board (on the right side).
2. Plug the other end of the cable to the Enhanced IDE hard drive,
with pin 1 on the cable corresponding to pin 1 on the hard drive.
(See your hard drive's documentation for the location of the
connector.)
Unlike floppy drives, you can make the connections with any of
the connectors on the cable. If you install two drives, you will
need to set one as the master and the other as the slave by using
jumpers on the drives. If you install just one drive, set it as the
master.