Aaeon PCM-6892 Rev.B, Руководство пользователя

Страница: 28 / 99

1 8 PCM-6892 Installation Guide
BC-
PCM-6892
LPT Connector (CN3)
Normally, the parallel port is used to connect the card to a printer.
The PCM-6892 includes an onboard parallel port, accessed
through the CN3 connector, a 26-pin flat-cable connector.
Pin Signal Pin Signal
1 #STROBE 14 #AFD
2 DATA0 15 #ERROR
3 DATA1 16 #INIT
4 DATA2 17 #SLIN
5 DATA3 18 GND
6 DATA4 19 GND
7 DATA5 20 GND
8 DATA6 21 GND
9 DATA7 22 GND
10 #ACK 23 GND
11 BUSY 24 GND
12 PE 25 GND
13 SELECT 26 N.C
FDD Connector (CN4)
You can attach up to two floppy disks to the PCM-6892's on-board
controller and use any combination of 5.25" (360 KB and 1.2 MB)
and/or 3.5" (720 KB, 1.44 MB, and 2.88 MB) drives.
The PCM-6892 CPU card comes with a 34-pin daisy-chain drive
connector cable. On one end of the cable is a 34-pin flat-cable
connector. There are two sets of floppy disk drive connectors, one
in the middle, and one on the other end. Each set consists of a 34-
pin flat-cable connector (usually used for 3.5" drives) and a
printed-circuit board connector (usually used for 5.25" drives).