- 2 -
WIRING TABLE
Keypad
Control Panel
Wire Color
▲
G
Data In
Green
−
−
Aux Pwr (GND)
Black
+
+ Aux Pwr
Red
▼
Y
Data Out
Yellow
Note:
NO (normally Open) and C (common) are the
connections for the relay output
+
6150RF-003-V2
NO C
Y
G
Figure 2 - 6150RFAAA Wiring Connections
APPLICATION GUIDELINES
Use the following guidelines when planning an installation:
•
Local wireless keys (wireless keys programmed directly into the 6150RFAAA) may be used regardless of whether
the RF receiver in the 6150RFAAA is enabled or disabled.
•
If using bi-directional devices, be sure to enable the transmitter module in the 6150RFAAA.
•
If transmitters are programmed into the control panel, be sure to enable the receiver. (Make sure you do not
exceed the number of receivers supported by the control panel.)
•
If a local wireless key is programmed to arm/disarm or to trigger a relay on the control panel, a user code must be
entered into the 6150RFAAA. This user code must also be programmed into the control panel.
•
You must set the House ID only if you are using RF keypads and/or bi-directional devices;
AND
the House ID
Source is the 6150RFAAA (Local).
6150RFAAA Application Guide
The following guide outlines how to program the wireless keys, RF receiver, and the House ID in the 6150RFAAA for
your installation.
* Two 6150RFAAAs are needed for this application: one assigned to partition 1 and one assigned to partition 2.
** If set for Local on a partition control, the 6150RFAAA’s partition assignment must match the one programmed in the BD device
An example of an installation using two 6150RFAAA
Keypad/Transceivers with 2-Way Wireless Devices (e.g.,
5828V) on Two Partitions is shown below:
Settings
6150RFAAA #1
6150RFAAA #2
Keypad:
Must be assigned to
Partition 1 in the
control panel
Must be assigned to
Partition 2 in the
control panel
House ID:
Match Partition 1
House ID in the
control panel and
House ID in Wireless
Device
Match House ID in
Wireless Device
House ID
Source:
System
Local
Receiver
Enable:
On
Off
Transmitter
Enable:
On
On
Are you using
6150RFAAA Programming Options
System Control Panel
RF keys
beyond
system’s
capacity?
RF receivers
beyond
system’s
capacity?
RF keypads and/or
Bi-directional
devices on more
than 1 partition?
Program
Wireless Keys
Into
Receiver
Enable
House ID
Source
**
NO
NO
N/A
System
ON [1]
System [1]
YES
NO
N/A
6150RFAAA
ON [1]
System [1]
VISTA-15PCN
YES
YES
N/A
6150RFAAA
OFF [0]
Local [0]
NO
NO
NO
System
ON [1]
System [1]
YES
NO
NO
6150RFAAA
ON [1]
System [1]
YES
YES
NO
6150RFAAA
OFF [0]
Local [0]
NO
YES
YES*
System
OFF [0]
Local [0]
VISTA-20PCN
YES
YES
YES*
6150RFAAA
OFF [0]
Local [0]
CONTROL
PANEL
6150RFAAA
#1
6150RFAAA
#2
