09/2021
Page 11
Instruction Manual
Jump starter Booster 12/24V 10000/5000A
■
Now PRESS „START/STOP“ for 3 seconds, until „ON“ blink on the display.
■
Release the button and the display show „STRT“
■
Until 30“ you can connect the clamps and start up the vehicle.
■
Identify the pole corresponding to the earth of the vehicle; this is generally
connected to the negative terminal.
CAUTION:
Never switch polarity. Always connect the output conductor with a red battery
clip (+) to the positive pole of the battery and the output conductor with a black
battery clip (-) to the vehicle‘s earth (ground).
CAUTION:
Inverting polarity can cause explosions, damage the vehicle, product and people.
CAUTION:
If the LED RED / REVERSE is set on, the polarity has been reversed. Disconnect
the battery clips from the vehicle and connect them correctly.
CAUTION:
Check that the cables of the Emergency Starter are far away from fans, from
moving parts and from the fuel conduit.
■
Once the vehicle has been started up, emergency starter automatically turns
off after 30 seconds. Otherwise press START/STOP button to turn off the
emergency starter.
■
Disconnect the output conductor with the black battery clip from the earth
of the vehicle and replace output conductor with the black battery clip in its
housing.
■
Disconnect the output conductor with the red battery clip from the positive
terminal (+) of the battery and return it immediately to its seat.
CAUTION:
If you are unable to start the vehicle within 5 seconds, do not continue with the
starting attempt. Before trying to start up the vehicle again, let the Emergency
Starter rest for at least 3 minutes to avoid damaging the appliance.
CAUTION:
Always recharge the Emergency Starter after each time that it is used.
