2 INTRODUCTION
Pag. 7 di 37
1.
TYPE
It identifies the model of the equipment as shown in the catalogue.
2.
CODE
It identifies the equipment order code.
3.
SERIAL N°
It progressively identifies the individual equipment.
The series number has been stamped should the tag go missing or be damaged. Always refer
to the series number for any kind of information.
4.
YEAR OF CONSTRUCTION
It indicates the year of construction.
5.
WEIGHT
It indicates the weight of the equipment in kg.
6.
THICKNESS
It indicates the thickness of the equipment in mm.
7.
CENTER OF GRAVITY
It indicates the distance in mm of the equipment CG center of gravity from the fork holding
plate table.
8.
NOMINAL CAPACITY
It indicates the maximum P load applicable to the hoisting equipment and the maximum CC
barycentric distance of the load itself.
9.
CLAMPING CAPACITY
Not applicable to this equipment.
10.
MAX OPERATING PRESSURE
It indicates the maximum pressure applicable to the equipment.
11.
MAX COUPLE
Not applicable to this equipment.
The A.T.I.B. - WIDE OPENING FORK POSITIONER TYPE 883 were planned and built to enable
the distance adjustment between fork centres through hydraulic actioning, all at the expected
operating pressures unless otherwise indicated in the case of specific applications (see
identification label).
SLI = with INTEGRAL SIDESHIFT
SLS = with SEMI-INTEGRAL SIDESHIFT
FB = with BOLTED FORKS
FS = with WELDED FORKS
This equipment must be applied between the fork holding plate of the lift truck and the forks,
and connected to the distributor by means of a hydraulic circuit.
The relative adjustment movement is carried out by means of two hydraulic cylinders which
act directly on the forks, which, suitably modified, slide on the relative bars.
The coupling components of the fork holding plate are manufactured in compliance with the
ISO 2328 norm.