A.O. Smith TRIASOFT MINI, Руководство пользователя

Страница: 37 / 84

ENG 35
Appliance stays in
regeneration
Noisy
• Controller not attached properly
• Foreign object in valve body
• Broken valve assembly. Motor running
• Air exits in the system
• Make sure the controller is pushed all the way onto the drive end
cap.
• Remove foreign object(s) from the valve body.
• Repair the drive end cap.
• Re-backwash the system to vent air.
PROBLEM POSSIBLE CAUSE SOLUTION
Incorrect Start Time of
Regeneration
Not regenerating in
proper sequence
Control backwashes at
excessively low or high
rate
Leaking
• Power outage causes inaccurate timing
• Magnet disk defective
• Defective controller
• Incorrect backwash controller used
• Foreign matter affecting controller operation
• Loose connecting • Tighten joints.
• According to the User Manual to reset the timer.
• Replace magnet disk.
• Replace controller.
• Replace with correct size controller.
• Remove controller and ball. Flush with water.