A.O. Smith STE - 400, Инструкция по установке, эксплуатации и обслуживанию

Страница: 21 / 23

Installation, User and Service Manual
21
5 Warranty
4.1 General warranty
4.2 Tank warranty
4.3 Conditions for
installation and use
If within one year of the original installation date of a storage water heater supplied by
A.O. Smith, following verification, and at the sole discretion of A.O. Smith, an assembly
or part (with exclusion of the tank) proves to be defective or fails to function correctly due
to manufacturing and/or material defects, then A.O. Smith shall repair or replace this
assembly or part.
If within 5 years of the original installation date of a storage water heater supplied by
A.O. Smith, following verification, and at the sole discretion of A.O. Smith, the glass-lined
steel tank proves to be leaking due to rust or corrosion occurring on the water side, then
A.O. Smith shall offer to replace the defective storage water heater with an entirely new
storage water heater of equivalent size and quality. The warranty period given on the
replacement storage water heater shall be equal to the remaining warranty period of the
original storage water heater that was supplied. Notwithstanding that stated earlier in this
article, in the event that unfiltered or softened water is used, or allowed to stand in the
storage water heater, the warranty shall be reduced to one year from the original
installation date.
The warranty set out in articles 1 and 2 will apply solely under the following conditions:
a. The storage water heater is installed under strict adherence to A.O. Smith installation
instructions for the specific model, and the relevant government and local authority
installation and building codes, rules and regulations in force at the time of
installation.
b. The storage water heater remains installed at the original site of installation.
c. The storage water heater is used exclusively with drinking water, which at all times
can freely circulate (a separately installed heat exchanger is mandatory for heating
saline water or corrosive water).
d. The tank is safeguarded against harmful scaling and lime build-up by means of
periodic maintenance.
e. The water temperatures in the heater do not exceed the maximum setting.
f. The water pressure and/or heat load do not exceed the maximum values stated on
the storage water heater plate.
g. The storage water heater is installed in a non-corrosive atmosphere or environment.
h. The storage water heater is connected to a protected cold supply arrangement,
which is: approved by the relevant authority; with sufficient capacity for this purpose;
supplying a pressure no greater than the working pressure stated on the storage
water heater; and where applicable by a likewise approved temperature and pressure
relief valve, fitted in accordance with installation instructions of A.O. Smith applying to
the specific model of storage water heater, and further in compliance with the
government and local authority installation and building codes, rules and regulations.
i. The storage water heater is at all times fitted with cathodic protection. If sacrificial
anodes are used for this, these must be replaced and renewed when, and as soon
as, they are 60% or more consumed. When power anodes are used, it is important to
ensure that they continue to work properly.